YFZ Central banner

sprocket question

1298 Views 8 Replies 8 Participants Last post by  yfzrider
Anybody knows if we can use a front sprocket of the wr 426 or yz?????
thanks!!!!

mike
03 yellow z-400
+3 a-arms
galfer steel braided brake line
hindle slip-on
proflow filter kit
hotcam stage 2
drz base gasket
kill switch pro design
a/c nerf, bumper, skid plate

04 yfz450 white
ordered nerf and skid plate a/c and a curtis complete pipe
1 - 9 of 9 Posts
So far everyone says yes. I haven't tried it though, so I couldn't give you a definite answer. :|
Sprocket specialtists part number 504-13 works.
You can use the same one that comes on the Raptor. I have done it and it is great. 13 tooth counter sprocket. :D
i used a 15th yz250 sproket worked great with the new 18 inch tires!
Yes. My 13 and 12 fit just fine - both are Renthal part numbers for the YZ.
Can you run the stock chain without shortening it, by using the adjusters on the swing arm, with the 12 tooth ? 13 tooth?
Originally posted by FAST1@Sep 8 2003, 09:26 AM
Can you run the stock chain without shortening it, by using the adjusters on the swing arm, with the 12 tooth ?  13 tooth?
The 13 yes. I have not had the 12 on yet - it would be close though.
yfzracer88 do you have enough chain to run a 15, I have a sprocket specialist 504-15 I am going to try. Also with running a 15 will it clear the stock case saver on the engine, anyone tried this yet? lemme know.
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top