YFZ Central banner
1 - 5 of 5 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter · #1 ·
I'm in the process of tearing down my 2014 yfz450. Im getting the frame, axle, hubs, and a-arms powder coated and was thinking about the motor as well. is this a good idea? will it affect my motor? and will the motor need completely torn down to be powder coated?

Any help would be great! thank you!
 

·
Registered
Joined
·
147 Posts
Depends how far you want to go. If you want to powder the cases too your going to have to disassemble the entire motor and take out all seal/bearing. The entire bottom end of my drag bike is powdered white but was done while the engine was being built.
 
  • Like
Reactions: kilroy

·
Registered
Joined
·
453 Posts
Steve the Quadfather Miller!!! He can hook you up with what you need, Look him up on Facebook
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top