[2000racing]

My grips are already worn down on my stock handlebars and I want to change them out without getting a whole new handlebar?How should I do this?

 

[FAST1]

you can cut them off or just do as I did and pull them off by peeling them back and inside out..

 

[YFZCentral]

i got some soapy water and a flat head screw driver. I then dipped the screw driver into the water and then shoved it inbetween the bars and grips. it came off eventually...just a lot of work.

 

[YFZ_53]

cut them....... u aint gunna be usin em again neway r u?

 

[pahrump]

I used a utility knife with a very sharp new blade installed.

They came off like butter :lol

 

[yfzthumpa]

:rock :rock

 

[Asher]

well if you have an air compressor and an air blower they will come off real easy :lol if the ends of your grips dont have a hole in em, make a tiny hole and blow air in it, the one on the other side will fly out, then do the same on the other side but since there isnt a grip anymore just put your hand around the bar to cover it when you put the blower in it, might sound dumb but i did this by mistake and blew the grip off of my twist throttle, and that thing is a pain in the ass to put back

 

[yfzthumpa]

not the stock one, they are glued arent they??? but the aircompresor works wonder putting the on, i find that a little bit of wd40 works awsome, an drys like glue!!! :yfz

 

[jbplays]

Originally posted by Pahrump@Nov 15 2003, 07:25 AM
I used a utility knife with a very sharp new blade installed.

They came off like butter :lol

DITTO! they are like a hot knife through butter

 

[Britboy]

spray contact cleaner down inside, and the will spin off in seconds

 

[RPyfz450]

Windex or rubbing alcahol works like a charm!

 

[YFZ Racer326]

Just take a razor blade and split them right down the middle then they should just peel off real easy. :yfz