YFZ Central banner
1 - 4 of 4 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Hows It Going?

Could someone please tell me where the negative lead from the battery grounds to the frame? I took my motor out a few years ago after I cracked the case and welded it. After that my poor quad sat in pieces in the garage untill last week when I finally got arond to putting it back together. Its obvious were the positive lead bolts to the starter but I just cant remember were the negative lead goes.

Thanks
 

·
Registered
Joined
·
106 Posts
Just ground it to the motor, at one of the casing bolts near the swing arm at the back(left side if you stand behind the bike)
Hope this helps
 

·
Premium Member
Joined
·
1,329 Posts
Theres a spot for it right behind the clutch lever coming off of the shaft...its the only spot really that the wire will reach too. Make sure you have a good nice clean ground area to work off of and you should be good to go!
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top