YFZ Central banner

1 - 6 of 6 Posts

·
Registered
Joined
·
126 Posts
Discussion Starter #1
According to the YFZ 450 owners manual its says to check the valve clearance at the first one month interval and then again at three months. It says to take it to the dealer because most likely we don't have the tools.

Also it says the same thing about the brakes,clutch, steering system, wheel bearings, front and rear suspension, fittings and fasteners, and light switches, upper and lower arm pivot and steering shaft, rear arm pivot. All to be checked at the first month and recommends taking it to the dealer.

I thought these were suposed to be low maintanence? I guess it can't hurt to take it in though.
 

·
Registered
Joined
·
2,092 Posts
If it is to get all that checked than yea I will. Especially since it is new. It doesnt cost the owner anything so you may as well. If it was just so the dealer could do a oil change etc. than no... I can do that but to check all that shit than yea I will.
 

·
Registered
Joined
·
32 Posts
I would expect it would cost you from any dealer. After all it's considered regular maintainence not a warranty repair.
 
1 - 6 of 6 Posts
Top