YFZ Central banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hey, new member getting ready to go check out a 2008 SE in the next couple days and I figured this would be the best place to study up so I don't go in blind.
The guy says it slips in 1st and 2nd, but that the other three gears are fine. He's thinking either tranny or clutch, but if it were the clutch, wouldn't ALL gears be slipping a bit? Been a long time since I've owned a quad (stolen in '05) so I'm definitely rusty on the maintenance side--especially since that was an 85 LT230.
I'd assume it would be either the first two gears themselves or a very SLIGHT possibility of the cable being just far enough out of adjustment, but I'm just guessing, really.
Any ideas would be great - thanks in advance
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top