YFZ Central banner
1 - 5 of 5 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
When I try to start my quad in any gear with the clutch pulled in fully the quad moves forward. I have checked the clutch basket and plates and everything looks fine. Just wondering what could cause this. The quad doesn't even run just has this problem as the starter is turning over. Thanks for the help!
 

·
Registered
Joined
·
20 Posts
I have the same problem. I don't really think anything is wrong just its cold and things are kinda stuck and the oil is thicker you know what I mean? After min warms up its fine, but I wouldn't worry about it too much
 

·
Registered
Joined
·
3 Posts
I had a similar situation. My metal plates were bad. Had dark spots on them. Some completely dark. I replaced the friction plates and the metal rings. Issue is gone. Also just a side note. Make sure the oil you are using is wet clutch compliant.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top