Just need some verification on a subframe....

[Slowprocess]

Originally Posted by Kovatch

I didn't have an issue with grab bars. I run the Houser "lowered" grab bar & had it bolted to a stock YFZR subframe, YFZ, and an LSR subframe for the YFZR. I never had one issue. hmm..

Here's the big question. Was the Houser grab bar originally for an R or for a standard yfz? The reason I ask is this.....A standard yfz grab bar appears to be able to fit all of the subframes....Standard yfz, the R, and the lsr. But looking at my R grab bar it seems the tabs are alittle shorter and bottom out on the frame before the holes line up. I have some pictures here I'll post up in just a second.

[Slowprocess]

On the first picture, notice the amount of frame between the very back of the subframe and the first grab bar bolt hole on each one. The R is a good bit shorter distance than the lsr. Also on the second picture it shows how far the holes are from lining up with the grab bar bottomed out on the frame. The third picture shows the grab bar bottomed out.

[Slowprocess]

Also wanted to add the grab bar I'm using for measuring purposes is a gytr grab bar for an R.